Easy Way To Hack WiFi Password WPA2/WEP/WPA Using Dumpper And JumpStart

We will be using software Dumpper and Jumpstart to hijack WPA2/WEP/WPA WiFi internet networks. So, essentially both software will work simultaneously, not using one of them. It will let you join without a password, and then you can get the password from inside the network. We will show you how towards the end of the tutorial. First step, download dumpper and jumpstar of the programs. Then follow these instructions for setting it up.

Requirement:

1. WPA/WPA2 WiFi network which you want to crack.
2. Laptop or personal computer with windows operation system.
3. Internal or External WiFi Adapter.
4. JumpStart.
5. Dumpper.
6. Wincap.

Limitations:

1. It will work on all the basic new routers and mostly all of the old routers.
2. This works on WPA/WPA2 network.
3. Not all networks can be hacked even if you satisfy the above 2 requirements because a small thing can alter the hack.

NOTE: You need to have Microsoft .NET Framework installed on your personal computer or laptop as well, or this will not work. You can install Microsoft .NET Framework here.

Easy Way To Hack WiFi Password:

1. first step, download and install Dumpper, JumpStart and WinPcap.
2. Open Dumpper programs. It’ll be in Spanish, so go to the far right tab and select "English" in between the other two options.Your programs are set up and ready to go, now begin the process:
3. In the "Networks" tab, select the network adapter you wish to use. Hit the "Scan" button now.
4. After it completes the scan, go over to the "Wps" tab. In the area that says "Connect using JumpStart", hit "Browse" to select the location of where you installed JumpStart in the previous set-up steps. {By default, it installs in C:\Program Files (x86)\Jumpstart. Don’t open it, just select the "Jumpstart" folder and click "OK"}
5. In the area "Show default PIN", select "All networks" isntead of "Only known networks".
6. Hit the "Scan" button.
7. Select the network you wish to penetrate. Remember the "PIN" corresponding to your network in the scan results, this will be needed for later.
8. In the previous area "Connect using Jumpstart", hit the "Start JumpStart" button.
9. Under "What do you want to do?", select "Join a wireless network" and hit "Next".
10. Under "Which setup method do you want to use?", select "Enter the PIN from my access point" and enter the PIN next to your network in the scan section back in the previous scan results.
11. Finally, select the targeted network from before and hit "Next". Now you’re happily connected to that WiFi network you just penetrated. Do you want to see the password so you can get on from other devices without doing this process? Sure! Follow these simple steps.
12. Open the menu where you join WiFi networks/view the network you’re connected to.
13. Right click on the network you just joined and hit "Properties".
14. Under the "Security" tab, you can see the password, but it is just dots. Check the "Show characters" box under it.
15. The password will then reveal itself.
16. Done.

Disclaimer: We don't take any responsibility for your actions regarding this tutorial. This tutorial  \was made by the creator only for educational purposes only and to demonstrate weaknesses in wireless networks. Becouse breaching other people’s wireless networks without permission is against the law. And if you want to test this tutorial, please to try it on your own home network. thanks.